Multiple Construct 1-5

After returning from my two and half week adventure into the high country, in the studio i feel very inspired to be immersed in all the projects. Without a stutter, like i hadn't been away, I went straight to work mounting the gun blued hinges. after a quick finish sanding and layout of the parts in there right sequence i began epoxying them onto each leaf of each book sculpture. Using 5 minute epoxy helps with to keep the process going at a reasonable pace. after each of the 5 pieces were assembled i could allow them to cure and then edge sand each to an edge square. next, tomorrow i'll head to the plastic shop to buy the .030 sheet styrene and start annoying Bill to gain access to the vacuform machine and produce the 10 reliefs for the outside pages of the 5 unit multiple.

Vacu-forming for a Multiple/1

My artist fishing friend Bill months ago had a great idea about repeating a part of my pieces over again through the use of a vacu-form machine. Last week I finally had time to find and buy the sheets of styrene. We bought a few differnt thicknesses so we could see the level of detail that would be created. After the initial tinkering to get the machine cleaned up and started which had its own learning curve, we were ready to test the first piece.
















After loading the reliefs on to the aluminum vacuum table, with the vacuum pump pulling 30lbs and the gas heaters running full blast Bill was ready to lower the very hot sheet of styrene onto the table and open the vacuum valve. After we tried about four test sheets we could see that the .030 thickness styrene sheets were giving us the best results. Only a slight webbing was occurring in the corners, and the detail that the thinnest sheets were more pleasing.

Now back to Piedmont Plastics next week for 12 sheets of Styrene, then we can go into production....  Thanks Bill!